A New York strip needs little more than a good sear, but a bright garlic-chili sauce makes it feel like a weekend dinner. This method uses a clean hot grate and a cooler side for finishing thick steaks. Keep the sauce separate from the grill so the garlic stays fragrant rather than burning in a flare-up.
Season without hiding the beef
Use steaks with similar thickness so they finish together. Pat them dry, sprinkle with salt and pepper, and let them sit briefly while you prepare the grill. If the steaks are especially thick, arrange a two-zone setup from the start.
Make the sauce gently
Warm olive oil in a small pan over low heat. Stir in minced garlic and thinly sliced red chili for a short time, just until fragrant; brown garlic becomes bitter. Remove from heat and add lemon juice, parsley, and a small pinch of salt. You can use chili flakes in place of fresh peppers.
Sear and finish
Grill the steaks over direct high heat until a crust develops, turning with tongs. If the crust is ready but the center needs more cooking, move the steaks to the cooler side with the lid closed. Measure temperature in the middle away from fat or bone. USDA recommends 145°F and a three-minute rest for whole steaks.
Serve without drowning the crust
Rest briefly on a clean board, then slice against the grain if sharing. Spoon a modest amount of warm garlic-chili sauce over each portion. Keep extra sauce at the table; the point is to complement the beef, not soak the steak.
Common mistakes to avoid
- Avoid adding garlic sauce before searing, which can scorch the garlic.
- Do not press steaks hard against the grate to force juices out.
- Do not use the raw-meat platter for cooked steaks.
Questions before you fire up the grill
Can I substitute ribeye?
Yes. Ribeye has more fat, so keep a cooler zone available to manage flare-ups.
What if my steak is under one inch thick?
Use a faster direct-heat cook and reduce time spent with the lid closed to avoid overshooting.
Printable recipe card
Grilled New York Strip Steaks with Garlic-Chili Sauce
Follow the steps as you cook, check off ingredients, or print the recipe alone.
Ingredients
Instructions
- Season steaks and prepare direct and indirect grill zones.
- Gently warm oil, garlic and chili until fragrant; take off heat.
- Add lemon juice and parsley to the sauce.
- Sear each steak over direct heat until browned, then move to lower heat if necessary.
- Check center temperature; for USDA minimum reach 145°F and rest 3 minutes.
- Slice if desired and spoon the warm sauce over.
Cooking temperatures and times vary with the thickness of your food and your equipment. Use a food thermometer where appropriate, follow the manufacturer’s instructions, and keep raw and ready-to-eat foods separate.
